Complete seal kit, Belmar KP-40

Listed for the Belmar KP-40/160 and KP-40/200, built 2013 to 2021, from serial number 21400. Machines below that take the kit ending -A; the page shows it as soon as you have entered the serial number, rather than putting both side by side and leaving you to choose.

Cross-references, one per line: manufacturer 4711-206. Predecessor 4711-204. Our number VM-40206.

Contents: two shaft seals 25×47×7 FKM, four O-rings 21×2.5 FKM, one paper flat gasket, one 5 g tube of assembly paste. The mechanical seal and the impeller are not included — both are listed separately because they vary with the series.

The match comes from the manufacturer's parts list. It is written here rather than in a PDF, because a data sheet you have to download is exactly the thing nobody reads at the moment it matters.

The kit gets fitted, and once fitted it cannot come back. So check the number on the bag against the number in your order confirmation before you open it. That takes ten seconds and saves the conversation that would otherwise happen two weeks later.

Unopened, we take it back within 30 days, from trade customers too, with no reason given. The window starts when the goods arrive, and the return form comes with the confirmation.

Excluded from returns are parts made to your specification or clearly tailored to your machine — made-up belts, turned bushes, shafts to a drawing. That is stated on the part before it goes into the cart, not afterwards in the confirmation.

Electrical components go to trade customers only. Proof of trade is checked once and the release then sits in your account. Without it the line stays in the basket and cannot be ordered — but it does not quietly disappear either.